|
      0KCY-07L
      Setting IPv4 Address
       
      The machine's IPv4 address can be either assigned automatically by a dynamic IP addressing protocol, such as DHCP, or entered manually. When connecting the machine to a wired LAN, make sure that the connectors of the LAN cable are firmly inserted into the ports (Connecting to a Wired LAN). You can test the network connection if necessary.
      Setting IPv4 Address
      1
      Tap <Menu> in the Home Screen.
      2
      Tap <Network Settings>.
      If a screen for entering a PIN is displayed, enter the PIN with the numeric keys and tap <Apply>. Setting the System Manager PIN
      3
      Select <TCP/IP Settings> <IPv4 Settings> <IP Address Settings>.
      4
      Configure IP address settings.
       <Auto Acquire>
      Select to automatically assign an IP address via a protocol such as DHCP. When <Auto Acquire: On> is displayed, automatic addressing is enabled.
       <Manually Acquire>
      Select to configure the IP address settings by manually entering an IP address. In order to select this option, <Auto Acquire> must be set to <Off>.
       <Check Settings>
      Select when you want to view the current IP address settings.
      Automatically assigning an IP address
      1
      Select <Auto Acquire>  <Select Protocol>.
      2
      Tap <DHCP>, <BOOTP>, or <RARP>.

      If you do not want to use DHCP/BOOTP/RARP to assign an IP address
      Select <Off>. If you select <DHCP>, <BOOTP>, or <RARP> when these services are unavailable, the machine will waste time and communications resources searching the network for these services.
      3
      Check that <Auto IP> is set to <On>.
      If <Off> is selected, change the setting to <On>.
      4
      Tap <Apply>.
      IP addresses assigned via DHCP/BOOTP/RARP override the address obtained via Auto IP.
      Manually entering an IP address
      1
      Check that <Auto Acquire> is set to <Off>.
      If <On> is displayed, tap <Auto Acquire>, and set both <Select Protocol> and <Auto IP> to <Off>.
      2
      Tap <Manually Acquire>.
      3
      Specify the IP address, subnet mask, and gateway address (or default gateway).
      Specify the settings in the following order: <IP Address>  <Subnet Mask>  <Gateway Address>.
      Enter each setting using the numeric keys, and tap <Apply>.
      Checking whether the settings are correct
      Make sure that the Remote UI screen can be displayed with your computer (Starting Remote UI). If a computer is not available, you can check the connection by using the operation panel (Testing the Network Connection).
      Testing the Network Connection
      1
      Tap <Menu> in the Home Screen.
      2
      Tap <Network Settings>.
      If a screen for entering a PIN is displayed, enter the PIN with the numeric keys and tap <Apply>. Setting the System Manager PIN
      3
      Select <TCP/IP Settings> <IPv4 Settings> <PING Command>.
      4
      Enter the IPv4 address of another device on the network, and tap <Apply>.
      If a proper connection has been established, the result is displayed as shown above.